Home | Healthy Lifestyle | Hobbies
Fathom this, stitching a basic stitch with your simple sewing machine and the needle gives out. The initial reaction that comes to mind is that your new purchase is defective and needs to be brought back to the place purchased, however many times needle breakage is caused by the sewer and not the sewing machine. To do away with repairs that are not needed, I will state frequent user issues and possible fixes. One common user problem is improper needle insertion into the machine. Many machines today use a needle that has a flat side and a round side. When replacing your broken needle you need make sure that the new needle is inserted into your machine with the flat side to the back of the machine. You must also make sure the needle is as far into the machine as possible. Many people are unaware that the needle goes farther into the machine and accidently only put the needle in half way; thus causing the machine to be un-calibrated and break a needle. A key thing to look at to help prevent the breakage of needles is the clamp screw. Often overlooked, it is critical that a clamp screw is tight and not unfastened. An unstable needle clamp screw leads to the needle falling out of the machine, consequently causing needle breakage. An additional dilemma, which often occurs and creates needle breakage, is faulty threading. An incorrectly threaded machine can lead to possible snares and tangles of thread, consequently this putting strain on the machine and often leads to unnecessary needle breakage. It is important to check for improper threading, as this is a common mistake that can easily be corrected. Machine tension is another aspect which should you should be wary of because unsuitable machine tension leads to preventable needle breakage. To avoid needle breakage due to improper tension, it is essential to make sure your tension is not set either too high or too low. An additional cause of needle breakage is using an inappropriate needle with a particular type of fabric. When a fabric is either too thick or too thin for a needle it can be the direct cause of needle breakage. Sewing on thick materials like leather or denim requires needles strong enough to handle the thickness of the material. Using needles strong enough to handle the thick fabric prevents needle breakage. Another thing to note is thread type because using the incorrect thread for certain fabrics can also cause needle breakage. Remember that polyester thread should be used for stretchy material while cotton thread should be used with non-stretch material. When using a good mixture or thread, needles, and fabric the result is a severe reduction of needle breakages. Pulling on fabric instead of letting the machine feed the fabric itself can create an unnecessary problem. This unnecessary strain could cause the needle to shatter or bend. A bent needle can result in needle breakage, or incorrect sewing. It is important to be wary of bent needles as well as broken needles for they can lead to disastrous sewing results. By following the simple steps and procedures above you can drastically reduce to amount of needles you break and save a lot of annoyance, irritations, and headaches.
Article Source: http://www.health-fitness-for-all.com
For additional instructions and content on stopping sewing needles from breaking, and other sewing machine related content come visit us at Mr Vac & Mrs Sew
Please Rate this Article
5 out of 54 out of 53 out of 52 out of 51 out of 5
Not yet Rated
Powered by Article Dashboard
